Setup for Cutting Cross-Lap Joint in Upright

Making Cuts in Crossbeam for Cross-Lap Joint

Cut Short Of Line For Later Fitting

Setup For Chopping and Paring Cross-Lap Joint

Waste Chopped From Cross-Lap Joint

Initial Paring Using Gauge Lines

Final Cuttting Of Shoulder Close-Up

Final Paring Using Gauge Lines and Measurement From Crossbeam

Unassembled Joint From Bottom Right

Cross on Bench

Assembled Joint From Bottom Right

Assembled Joint From Bottom Right Close-Up

Assembled Joint From Bottom Left

Assembled Joint From Top Left

Assembled Joint From Top Right

Assembled Cross on Bench

Back of Assembled Joint from Bottom Left

Finished Cross from Back

Cross Hung On Wall

Cross Hung On Wall Close-Up

Cross Hung On Wall From Underneath

End Wall Of Good Hope Horizontal Shot

End Wall Of Good Hope Vertical Shot